Pitch, rafters + sheets
Calculate the cost of roof framing, including trusses, rafters, purlins, and roofing material, adjusted for Caribbean wind loads and pitch preferences.
Pitched roofs (20–45 degrees) are preferred for rain runoff. Flat roofs are common in commercial. Higher pitch = higher cost.
Pre-made trusses can save labor but cost more material. On-site framing uses less material but more labor. Compare both for your project.
Zinc (galvanized steel) is cheaper and faster to install; tiles are more durable but costly. Each has trade-offs in Jamaica's climate.
TOTAL
J$0.00
Add a section for each roof plane on the house — e.g. a hip section and a gable section. They're priced together.
4.00:12 · 18.43° · 33.3% · factor 1.054 · Conventional
When the drawing gives an angle or a percent slope instead of rise:12.
Between 1 and 89
= 0.00:12 · 0.0% · 0.00° · factor 1.000 · Flat
| Pitch | Degrees | % slope | Factor | Category |
|---|---|---|---|---|
| 2:12 | 9.5° | 17% | 1.014 | Low-slope |
| 3:12 | 14.0° | 25% | 1.031 | Low-slope |
| 4:12 | 18.4° | 33% | 1.054 | Conventional |
| 5:12 | 22.6° | 42% | 1.083 | Conventional |
| 6:12 | 26.6° | 50% | 1.118 | Conventional |
| 7:12 | 30.3° | 58% | 1.158 | Conventional |
| 8:12 | 33.7° | 67% | 1.202 | Steep-slope |
| 9:12 | 36.9° | 75% | 1.250 | Steep-slope |
| 10:12 | 39.8° | 83% | 1.302 | Steep-slope |
| 12:12 | 45.0° | 100% | 1.414 | Steep-slope |
Internal corners where two roof planes meet
One tie-down strap per rafter seat — expected by code in hurricane zones.